Category: Intermediate Concepts Mechanical Eng

  • Measurement Procedure

    The spindle of an ordinary metric micrometer has two threads per mm, and thus one complete revolution moves the spindle through a distance of 0.5 mm. The longitudinal line on the frame is graduated with 1 mm divisions and 0.5 mm subdivisions. The thimble has 50 graduations, each being 0.01 mm (one-hundredth of a mm).…

  • MICROMETER OR SCREW GAUGE

    A micrometer is also known as a screw gauge: It consists of a calibrated screw and is used for precise measurement of small length. The first ever micrometric screw was invented by William Gascoigne in the 17th century, as an enhancement of the vernier; it was used in a telescope to measure angular distances between…

  • Precautions in Use of Vernier Calipers

    The following precautions must be taken in using the vernier calipers:

  • VERNIER CALIPERS

    Vernier calipers are used for more accurate measurement than that of a slide caliper. It can measure internal and external dimensions; it can also be used as a depth gauge and height gauge. Vernier calipers are available with metric and imperial graduations. A sample of vernier caliper is shown in Figure 18.16 with name of different parts. Figure…

  • UNCERTAINTIES OF MEASUREMENT

    Uncertainty of measurement is the doubt that exists about the result of any measurement. You might think that well-made rulers, clocks, and thermometers should be trustworthy and give the right answers. But for every measurement even the most careful, there is always a margin of doubt. In everyday speech, this might be expressed as ‘give…

  • MEASUREMENT ERRORS

    No measurement is exact. When a quantity is measured, the outcome depends on the measuring system, the measurement procedure, the skill of the operator, the environment, and other effects. Even if the quantity were to be measured several times, in the same way and in the same circumstances, a different measured value would in general…

  • Torque Measurement by Pointer and Scale

    Suppose the angle of twist on the shaft due to application of torque T is θ, which can be directly read by pointer and scale (Figure 18.15). The value of torque applied is directly related to angle of twist as Figure 18.15 Torque Measurement by Pointer and Scale where L is the length of the shaft; J is polar moment of inertia; and G is…

  • Rope Brake Dynamometer

    Rope brake dynamometer consists of a rope wound round the rim of the pulley fixed to the shaft of the engine whose torque is to be measured. The upper end of the rope is attached with a spring balance of stiffness S and lower end of the rope is attached with a load W as shown in Figure 18.14. If the…

  • Prony Brake Dynamometer

    A Prony brake (Figure 18.13) develops mechanical friction on the periphery of a rotating pulley by means of brake blocks that are squeezed against the wheel by tightening the bolts until the friction torque F · R balances the torque W · L.   Torque, T = F × R = W × L Figure 18.13 Prony Brake Dynamometer

  • TORQUE MEASUREMENT

    A torque is a vector product of force and radial distance that measures the tendency of a force to rotate an object about an axis or centre. A dynamometer is a device for measuring mechanical force, or power, transmitted by a rotating shaft. Since power is the product of torque and angular speed, all power-measuring…