Category: Basic Industrial Engineering
-
General Wastewater Discharge Permit
General permits are wastewater discharge permits that are developed for a category of discharger instead of an individual facility. General permits may be issued under federal (actually combined NPDES/state) or state‐only authority. The Waste Discharge General Permit Program rule, Chapter 173‐226 WAC, clarifies the intent in its purpose statement: “Permits issued under this chapter are designed…
-
NPDES Wastewater Discharge Permit
An NPDES Permit is required for a discharge of wastewater to waters of the United States (surface waters). This permit is issued by the state by delegated authority of the Clean Water Act (CWA 1972). Since waters of the United States are also waters of the state, NPDES permits are actually combined NPDES/state waste discharge permits issued under dual…
-
Analytical Methods
POTWs with approved pretreatment programs may, at their discretion (as authorized by their local ordinances and regulations), require their indirect dischargers to achieve specific minimum levels when performing analyses or may require the use of specific analytical methods to enable the POTW to better characterize contributions into their system. Where a state or the EPA is…
-
Purposes and Objectives for Inspecting and Sampling
Having National Pollutant Discharge Elimination System (NPDES) permit holder, each industrial facility with an approved pretreatment program with/without working with a publicly owned treatment works (POTW), must implement its compliance monitoring program that (i) meets the requirements and intent of the General Pretreatment Regulations, (ii) is effective and timely in determining compliance with categorical standards, local limits, and…
-
Common Elements, Radicals, and Chemicals in Water Analysis
Names of elements common to water and wastewater technology along with their symbols, atomic weights, common valence, and equivalent weights are given in Table 4.1. Certain groupings of atoms act together as a unit in a large number of different molecules; these refer to radicals, are given special names, such as the hydroxyl group (OH−). The…
-
Industrial Process Water
In industrial process, the control of the quality of process water can be critical to the quality of the end product. Water is often used as a carrier of reagents and the loss of reagents to product must be continuously monitored to ensure that correct replacement rate is made. Parameters measured relate specifically to the…
-
Introduction
This chapter describes and deals with important aspects of selecting the best remedial control technologies for pollutants, managing wastes, monitoring, sampling industrial water, air, and solid and hazardous materials, modes of sample collections, samples analyses by various analytical, physical‐chemical methods approved by governmental agency, quality control (QC) and quality assurance (QA), laboratory audits, testing, monitoring,…
-
Nuclear Waste Management
Of particular concern in nuclear waste management are two long‐lived fission products, Tc‐99 (half‐life 220 000 years) and I‐129 (half‐life 15.7 million years), which dominate spent fuel radioactivity after a few thousand years. The most troublesome transuranic elements in spent fuel are Np‐237 (half‐life two million years) and Pu‐239 (half‐life 24 000 years) (Nuclear Decommissioning Authority 2014). Nuclear waste requires sophisticated treatment…
-
Coal
Coal contains a small amount of radioactive uranium, barium, thorium, and potassium but, in the case of pure coal, this is significantly less than the average concentration of those elements in the Earth’s crust. The surrounding strata, if shale or mudstone, often contain slightly more than average and this may also be reflected in the…
-
Incineration, Destruction, and WtE
Hazardous waste may be “destroyed.” For example, by incinerating it at a high temperature, flammable wastes can sometimes be burned as energy sources. For example, many cement kilns burn hazardous wastes like used oils or solvents. Today, incineration treatments not only reduce the amount of hazardous waste but also generate energy from the gases released in…