The Zone near the Well, the Sandface, and the Well Completion

The zone surrounding a well is important. First, even without any man-made disturbance, converging, radial flow results in a considerable pressure drop around the wellbore and, as will be demonstrated the pressure drop away from the well varies logarithmically with the distance. This means that the pressure drop in the first foot away from the well is naturally equal to that 10 feet away and equal to that 100 feet away, and so on. Second, all intrusive activities such as drilling, cementing, and well completion are certain to alter the condition of the reservoir near the well. This is usually detrimental and it is not inconceivable that in some cases 90% of the total pressure drop in the reservoir may be consumed in a zone just a few feet away from the well.

Matrix stimulation is intended to recover or even improve the near-wellbore permeability. (There is damage associated even with stimulation. It is the net effect that is expected to be beneficial.) Hydraulic fracturing, today one of the most widely practiced well-completion techniques, alters the manner by which fluids flow to the well; one of the most profound effects is that near-well radial flow and the damage associated with it are eliminated.

Many wells are cemented and cased. One of the purposes of cementing is to support the casing, but at formation depths the most important reason is to provide zonal isolation. Contamination of the produced fluid from the other formations or the loss of fluid into other formations can be envisioned readily in an open-hole completion. If no zonal isolation or wellbore stability problems are present, the well can be open hole. A cemented and cased well must be perforated in order to reestablish communication with the reservoir. Slotted liners can be used if a cemented and cased well is not deemed necessary and are particularly common in horizontal wells where cementing is more difficult.

Finally, to combat the problems of sand or other fines production, screens can be placed between the well and the formation. Gravel packing can be used as an additional safeguard and as a means to keep permeability-reducing fines away from the well.

The various well completions and the resulting near-wellbore zones are shown in Figure 1-5.

Image

Figure 1-5. Options for well completions.

The ability to direct the drilling of a well allows the creation of highly deviated, horizontal, and complex wells. In these cases, a longer to far longer exposure of the well with the reservoir is accomplished than would be the case for vertical wells.

The Well

Entrance of fluids into the well, following their flow through the porous medium, the near-well zone, and the completion assembly, requires that they are lifted through the well up to the surface.

There is a required flowing pressure gradient between the bottomhole and the well head. The pressure gradient consists of the potential energy difference (hydrostatic pressure) and the frictional pressure drop. The former depends on the reservoir depth and the latter depends on the well length.

If the bottomhole pressure is sufficient to lift the fluids to the top, then the well is “naturally flowing.” Otherwise, artificial lift is indicated. Mechanical lift can be supplied by a pump. Another technique is to reduce the density of the fluid in the well and thus to reduce the hydrostatic pressure. This is accomplished by the injection of lean gas in a designated spot along the well. This is known as “gas lift.”


Comments

Leave a Reply

Your email address will not be published. Required fields are marked *