Requirements of Formwork

Irrespective of the type of material used the formwork should satisfy the following requirements:

1. Adequate strength
2. Smooth inner surface
3. Enough rigidity
4. Quality
5. Less leakage
6. Economy
7. Easy removal
8. Supports

1. Adequate Strength

As the formwork has to bear the weight of concrete which exerts a lot of pressure on all sides when it is wet, strength is an important and essential requirement. Resistance to outward push is achieved with the help of bracings and the wire fastened on the outer side of the formwork. Further the temporary load during placing of concrete by men and machinery should also be withstood by the formwork.

2. Smooth Inner Surface

It is an essential requirement that the inner surface of the formwork to have smooth surface on all concrete structures. This is specially desired, in case, the concrete is to be exposed without plastering. All the projections, if any, are to be smoothened before concreting. Steel sheet formworks give a smooth surface. Further it is the practice to apply crude oil or soft soap solution to the inside surface of the formwork. This also further makes the removal of formwork easy.

3. Enough Rigidity

The formwork should be rigid enough to retain the shape without undue deformation. For visible finished surfaces, the allowable deformation is 1/300 of span and 1/150 of span for hidden surface. In order to use the formworks repeatedly, they should be rigid, robust and stiff.

4. Quality

Formwork should be designed correctly such that the required size, shape and finish are obtained. Particularly the verticality of the side formwork should be made. In order to avoid leakages through the formwork, the timber used for formwork should not have any cracks or holes.

5. Less Leakage

Adequate care is taken to see that the formwork should be so placed that there is minimum joint. Sometimes joints open once some concrete is placed. This should be avoided and the leakage should be corrected by adjusting the vertical supporting poles of the formwork.

6. Economy

The cost of the formwork should be minimum as the formwork is only a temporary structure and not going to contribute to the stability of the structure. This demands a careful selection of formwork material and an optimum design.

7. Easy Removal

Formwork should be placed in such a manner that it can be removed easily without causing any damage to the structure. During removal of the formwork, the nails and screws should be removed with little hammering. Such a careful removal prevents the possibility of injury to the concrete. Further such smooth removal enables the formwork to be re-used with less expense.

8. Supports

In general formwork should rest on strong, hard and non-yielding supports. For this the ground should be hard or the supports should rest on cured base concrete. The vertical poles supporting the formwork should be strong and should not due to the weight of concrete.